Replace your worn-out steel roller bearing on your sliding door with this low-friction solution!
The outer roller surface is machined from Delrin® AF blend, a super tough material impregnated with Teflon® fibers for quiet, low-friction operation. The sealed precision ball bearing keeps out dirt and provides a smooth rolling action.
This roller bearing fits the rear "arm" that swings out of the slider track. Check out the Schematic Shop tab for a location drawing.
Installation Note: You shouldn't need to hammer these bearings on. If the fit over the shaft is snug, take some sandpaper or similar abrasive and clean any corrosion or debris off the shaft before fitting. If any force is needed to seat it, press on the inner race of the bearing, not the outer Delrin® piece.
Looking to upgrade your all your bearings? Check out our Sliding Door Roller Bundle in the related products section below!
Some 1984 Vanagon, and all 1985-91 Vanagon. If you have an '84, please check to see if your van has this roller. Some earlier models have a plastic bushing in this location (which means this metal roller bushing will NOT fit!).